For more information on the HP LaserJet P3010 | P3015 visit us at www.PrinterSupplies.com or call 800-551-1943
3. Carefully unwind the wire harness (callout 1) from the retainer on the gear cover (callout 2), and
then remove the cover.
Reinstallation tip When you reinstall the gear cover, make sure that you wrap the solenoid-wire
harness around the retainer on and on-half times in a clockwise direction.
Figure 2-108 Cassette pickup (Tray 2) or Tray 1 (multipurpose tray) solenoid (2 of 3)
1
2
4. For the cassette (Tray 2) pickup solenoid: Remove one screw (callout 1), and then remove the
solenoid (callout 2).
For the Tray 1 (multipurpose tray) pickup solenoid: Remove one screw (callout 3), and then
remove the solenoid (callout 4).
Figure 2-109 Cassette pickup (Tray 2) or Tray 1 (multipurpose tray) solenoid (3 of 3)
1
4
3
2
116 Chapter 2 Removal and replacement ENWW
To Next Page
Loading...
