For more information on the HP LaserJet P3010 | P3015 visit us at www.PrinterSupplies.com or call 800-551-1943
Condensation
●
Does condensation occur following a temperature change (particularly in winter following cold
storage)? If so, wipe off the affected parts or leave the product on for 10 to 20 minutes and then try
to resume printing.
●
Was a print cartridge opened soon after it was moved from a cold room to a warm one? If so, allow
the print cartridge and the product to acclimate to room temperature for one to two hours.
Miscellaneous
●
Are any non-HP components installed? Check for any non-HP components (print cartridge, memory
modules, and EIO cards) installed in the product and remove them. Hewlett-Packard recommends
the use of HP components in its products.
●
Network models only: Remove the product from the network, and make sure that the failure is with
the product before beginning troubleshooting.
Table 3-1 Initial troubleshooting checklist (continued)
ENWW Solve problems checklist 129
To Next Page
Loading...
