Service menu
Use this menu to restore default settings, clean the product, and activate special modes that affect print
output. Items that have asterisks (*) indicate the factory default setting.
Menu item Sub-menu item Description
Cleaning Page Use this option to clean the product if you see toner
specks or other marks on the printed output. The
cleaning process removes dust and excess toner from
the paper path.
When you select this item, the product prompts you to
load plain paper in Tray 1 and then press the OK
button to start the cleaning process. Wait until the
process is complete. Discard the page that prints.
USB Speed High*
Full
For the product to actually operate at high speed, it
must have high speed enabled and be connected to
an EHCI host controller that is also operating at high
speed. This menu item also does not reflect the current
operating speed of the product.
Less Paper Curl On
Off*
If printed pages are consistently curled, use this
option to set the product to a mode that reduces curl.
Archive Print On
Off*
If you are printing pages that will be stored for a long
time, use this option to set the product to a mode that
reduces toner smearing and dusting.
Firmware Date Displays the current firmware datecode.
Restore Defaults Sets all customized menu settings to the factory
default values.
HP Smart Install On*
Off
Enable or disable the HP Smart Install tool.
Disable the tool if you want to connect to a network
by using an Ethernet cable.
16 Chapter 2 Control panel menus ENWW
To Next Page
Loading...
