Network Setup menu
Use this menu to establish network configuration settings. Items that have asterisks (*) indicate the
factory default setting.
Menu item Sub-menu item Description
Wireless Menu (wireless products
only)
NOTE: You can also access this
menu by pressing the Wireless
button on the control panel.
WPS Setup If your wireless router supports this feature, use this method
to set up the product on a wireless network. This is the
simplest method.
Network Test Tests the wireless network and prints a report with the
results.
Wireless Off/On Enable or disable the wireless network feature.
TCP IP Config Automatic*
Manual
Select the Automatic option to automatically configure
all the TCP/IP settings.
Select the Manual option to manually configure the IP
address, subnet mask, and default gateway.
Auto Crossover On*
Off
Enables or disables the use of a standard 10/100
network cable when the product is directly connected to a
computer.
Network Services IPv4
IPv6
Enable or disable the IPv4 and IPv6 protocols. By default,
each protocol is enabled.
Show IP Address No
Yes*
No: The product IP address will not appear on the control
panel display.
Yes: The product IP address will appear on the control
panel display.
Link Speed Automatic*
10T Full
10T Half
100TX Full
100TX Half
Sets the link speed manually if needed.
After setting the link speed, the product automatically
restarts.
Restore Defaults Restores the network configuration settings to the default
values.
ENWW
Network Setup menu
17
To Next Page
Loading...
