1-14 Product Information Service Manual
Operation
This section gives an overview of the notebook’s operation.
Turning the Notebook On and Off
You can start and stop your notebook using its power button. However, at certain times you might want to
use other methods to start or stop the notebook—depending on power considerations, types of active
connections, and start-up time.
NOTE: This manual describes the notebook in its original factory configuration, with all settings at their
default values.
Table 1-2. Activating Power Modes
Power mode To enter this mode
On
Power mode status light is on
Press the power button
Standby mode
Saves significant power
Turns off the display and other components
Maintains current session in RAM
Restarts quickly
Restores network connections
Power mode status light blinks
Press the power button
–or–
select Start > Turn Off Computer > Stand By (Windows XP)
–or–
select Start > Shut Down > Standby (Windows 2000)
–or–
allow timeout
Hibernation mode
Saves maximum power
Saves current session to disk, and then shuts down.
Restores network connections
Power mode status light is off
Press
Fn+F12
–or–
select Start > Shut Down > Hibernate (Windows 2000)
–or–
allow timeout
Shut down (off)
Saves maximum power
Turns off without saving current session
At startup, resets everything, starts a new session, and
restores network connections.
Power mode status light is off
Select Start > Turn Off Computer > Turn Off (Windows XP)
–or–
Select Start > Shut Down > Shut down (Windows 2000)
–or–
press the power button for 4 seconds (only if the Start menu
procedure doesn’t work)
To turn on: Press the power button to restart, or to resume your session from Standby or Hibernation mode.
To Next Page
Loading...
Need help?
General