Service Manual Removal and Replacement 2-63
Removing Other Components
(Authorized Service Providers Only)
Required Equipment
• 0 and 1 Phillips screwdrivers
• Small flat-blade screwdriver
Removal Procedure
1. Unplug the AC adapter, if present, and then remove the battery.
2. Remove the assemblies, and then follow the additional steps listed in the table below.
Table 2-5. Removing Components
Component Removal Procedure Additional Steps
Battery, CMOS
Keyboard cover(page 2-13)
Speaker (page 2-15)
Keyboard (page 2-16)
Switchboard PCA(page 2-19)
CD/DVD (page 2-20
Display (page 2-23)
Top case (page 2-26)
Floppy (page 2-32)
Heat sink (page 2-40)
Motherboard (page 2-50)
Reassembly Notes: After replacing the CMOS
battery, set the correct time and date using the
BIOS Setup utility or Date/Time in the Control
Panel.
Case, bottom
See page 2-3
Case, top
See page 2-3
CD/DVD drive
See page 2-3
CPU module
See page 2-44
Display assembly
See page 2-23.
Doors, PCMCIA
Keyboard cover(page 2-13)
Speaker (page 2-15)
Keyboard (page 2-16)
Switchboard PCA(page 2-19)
CD/DVD (page 2-20
Display (page 2-23)
Top case (page 2-26)
Heat sink (page 2-40)
Floppy (page 2-32)
Motherboard (page 2-50)
See page 2-3
Floppy drive
See page 2-32
To Next Page
Loading...
