HP PCL 5 - User-Defined Symbol Sets

EN Introduction 10-1
10
User-Defined Symbol
Sets
Introduction
User-defined symbol sets are used with unbound scalable fonts.
Three new commands provide for the implementation of
user-defined symbol sets:
Symbol Set ID Code -
E
C
*c#R
Define Symbol Set -
E
C
(f#W [symbol set data]
Symbol Set Control -
E
C
*c#S
To define a symbol set, you must first designate a symbol set ID
code. Next, use the Define Symbol Set command to download
the list of characters (character codes and related symbol index
numbers) for the symbol set. Once this is accomplished, you may
select the symbol set for printing in the same manner as any
symbol set using the symbol set selection sequence:
E
C
(ID
Once a user-defined symbol set is downloaded, the Symbol Set
Control command can be used to assign symbol sets as either
temporary or permanent and to delete them.