EN Status Response Syntax 16-7
PCL<CR><LF>
INFO FONTS<CR><LF>
SELECT=“<Esc>(8U<Esc>(s0p10.00h12.00v0s0b3T”<CR><LF>
SELECT=“<Esc>(0N<Esc>(s0p16.67h8.5v0s0b0T”<CR><LF>
SELECT=“<Esc>(s1p__v1s0b4101T<Esc>(78X”<CR><LF>
SYMBOLSETS=“0D,0I,0N,0S,0U,1E,1F,1G,...”<CR><LF>
SELECT=“<Esc>(8U<Esc>(s1p__v0s3b4148T”<CR><LF>
<FF>
Notes In the example listings, “<CR>,” “<LF>,” and “<FF>” identify the
Carriage Return (decimal 13), Line Feed (decimal 10), and Form
Feed (decimal 12) control codes. The “<Esc>” following the
“SELECT=” keyword is a five character representation (the printable
characters: “<,” “E,” “s,” “c,” and “>”) and does not identify an escape
control code (decimal 27).
The examples in the remainder of this chapter do not show the status
response line termination (“<CR><LF>”) control codes, or the
termination (“<FF>”) control code.
Example responses in this chapter for “SYMBOLSETS=” do not list
the complete list of internal available symbol sets, only a partial list:
“0D,0I,0N,0S,0U,1E,1F,1G,...” The internal symbol sets are printer
dependent and may vary from printer to printer. Refer to the PCL 5
Comparison Guide for printer specific information.
To Next Page
Loading...
