Table 6-3 Computer Setup—Advanced (for advanced users) (continued)
Option Heading
Built-In Device Options Embedded LAN Controller
Select to show the device in the operating system. Default is enabled.
Wake On LAN
Lets you either disable the Wake On LAN feature or congure where the computer boots, including the
network or hard drive. Default is Boot to Network.
Allow No Panel conguration
When enabled, POST blink and beep codes and error messages are not generated. Default is disabled.
Video memory size
Use this option to manage graphics memory allocation. The value you choose is allocated permanently to
graphics and is unavailable to the operating system.
Integrated Camera
Clear to disable the integrated camera. Default is enabled.
Audio Device
Select to show the device in the operating system. Default is enabled.
Integrated Microphone
Clear to disable the integrated microphone. This does not aect devices plugged into audio jacks. Default is
enabled.
Internal Speakers (does not aect external speakers)
Clear to disable the chassis speaker or speakers. This function is applicable to normal audio playback in the
operating system and does not aect the error or warning beeps during POST. Default is enabled.
Headphone Output
Clear to disable the headphone jack. Default is enabled.
Collaboration Buttons
Clear to disable the collaboration buttons. Default is enabled.
Button Sensitivity
Select from low, medium, or high. Default is low.
LAN/WLAN auto switching
Select to enable auto switching between a wired and wireless connection. Default is disabled.
Wake on WLAN
Select to enable wake on WLAN. Default is disabled.
M.2 USB/Bluetooth
Select to enable the M.2 controller. Default is enabled.
Increase Idle Fan Speed(%)
Sets idle fan speed percentage. This setting only changes the minimum fan speed. The fan is still
automatically controlled.
ENWW Computer Setup—Advanced 87
To Next Page
Loading...
