EasyManuals Logo

HP ProLiant BL620c - G7 Server User Manual

HP ProLiant BL620c - G7 Server
190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
Error messages 111
Write Memory Error
Description: Data cannot be written to the cache memory. This typically means that a parity error was
detected while writing data to the cache. This can be caused by an incomplete connection between the
cache and the controller. This is not a data loss circumstance.
Action: Power down the system and be sure that the cache board is fully connected to the controller.
Wrong Accelerator
Description: This may mean that the board was replaced in the wrong slot or was placed in a system
previously configured with another board type. Included with this message is a message indicating (1) the
type of adapter sensed by ADU ("Array diagnostic software" on page 76), and (2) the type of adapter
last configured in EISA NVRAM.
Action: Check the diagnosis screen for other error messages. Run the server setup utility to update the
system configuration.
ADU version 8.0 through 8.28 error messages
This section contains a complete alphabetical list of all ADU ("Array diagnostic software" on page 76)
error messages. ADU is being replaced by the ACU diagnostics feature ("Diagnostics tasks" on page 70).
If the following versions are installed on the server, see the messages in this section:
ADU version 8.0 through ADU version 8.25
ACU diagnostics 8.28 and later
Array Accelerator: The batteries were hot-removed.
Action: Replace the batteries.
Array Accelerator: The cache is disabled because the batteries are low on the
redundant controller.
Action: Replace the batteries if the batteries do not recharge within 36 powered-on hours.
Array Accelerator: The cache for this controller is temporarily disabled since a
snapshot is in progress....
...The controller requires a reboot to enable the cache. Until the reboot occurs, array accelerator operations such as
Expansion, Extension, and Migration are disabled.
Action: Reboot the Controller to enable the cache. Until the reboot occurs, array accelerator operations
such as Expansion, Extension, and Migration are disabled.
Array Accelerator: The cache is disabled because the batteries are low.
Action: Replace the batteries if the batteries do not recharge within 36 powered-on hours.

Table of Contents

Other manuals for HP ProLiant BL620c - G7 Server

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProLiant BL620c - G7 Server and is the answer not in the manual?

HP ProLiant BL620c - G7 Server Specifications

General IconGeneral
BrandHP
ModelProLiant BL620c - G7 Server
CategoryServer
LanguageEnglish

Related product manuals