If the server is in rack mode: Install the server on the tray .
18. Connect all peripheral cables to the server.
19. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
20. To configure drive arrays and logical drives, use UEFI System Utilities or HPE Smart Storage Administrator (HPE SSA).
For more information, see the HPE Smart Array SR Gen10 Configuration Guide on the Hewlett Packard Enterprise website
(https://www.hpe.com/info/smartstorage-docshttps://www.hpe.com/info/smartstorage-docs
).
The installation is complete.
To Next Page
Loading...
