Hardware options installation 61
11. Connect the Mini-SAS cables from the drive backplane to the HP Flexible Smart Array Controller.
o SFF configuration
o LFF configuration
12. Install the screws and cable clips on the system board.
13. Install the fan cage (on page 37).
14. Install the air baffle (on page 34).
15. Install the access panel (on page 32).
16. Do one of the following:
o If the server is in a tower configuration, return the server to an upright position.
o If the server is in a rack configuration, slide the server into the rack.
17. Connect each power cord to the server.
18. Connect each power cord to the power source.
To Next Page
Loading...
