HP ProLiant ML350 Generation 4 - Removal and Replacement Procedures; Required Tools; In this Section Required Tools

11
Removal and Replacement Procedures
In This Section
Required Tools .............................................................................................................................11
Safety Considerations...................................................................................................................12
Preparation Procedures.................................................................................................................15
Removing Tower Feet ..................................................................................................................19
Removing the Front Bezel (Tower Model) ..................................................................................19
Rack Rails.....................................................................................................................................20
Removing the Power Supply Blank..............................................................................................21
Hot-Plug Power Supply................................................................................................................21
Non-Hot-Plug Power Supply........................................................................................................22
Hot-Plug Power Supply Backplane ..............................................................................................24
Removing a Hard Drive Blank .....................................................................................................24
Hot-Plug SCSI Hard Drive...........................................................................................................25
Non-Hot-Plug SCSI Hard Drive...................................................................................................26
Redundant System Fan .................................................................................................................28
Expansion Slot Cover...................................................................................................................29
Expansion Board ..........................................................................................................................30
CD-ROM Drive............................................................................................................................31
Tape Drive....................................................................................................................................32
Internal Two-Bay Hot-Plug SCSI Drive Cage .............................................................................33
Processor and Heatsink.................................................................................................................35
PPM ..............................................................................................................................................39
Second Serial Port ........................................................................................................................40
Duplex SCSI Backplane ...............................................................................................................41
Battery ..........................................................................................................................................43
System Board................................................................................................................................44
Re-Entering the Server Serial Number and Product ID................................................................45
•
Required Tools
You need the following items for some procedures:
Torx T-15 screwdriver