HP ProLiant ML350 Generation 4 - Power Requirements

28 HP ProLiant ML350 Generation 4 Server Maintenance and Service Guide
2. Install two screws on the side of the hard drive to ensure proper alignment
inside the bay.
3. Replace the hard drive into the hard drive bay, and reinstall the screws.
4. Reconnect the power cable and the four-device SCSI cable to the hard drive.
5. Replace the access panel ("Access Panel" on page 17
).
Redundant System Fan
CAUTION: The redundant system fan is not hot-pluggable.
To remove the redundant system fan:
1. Remove the access panel ("Access Panel" on page 17
).
2. Remove the redundant system fan cable from the redundant system fan
header on the system board.