Removal and Replacement Procedures 25
CAUTION: To prevent improper cooling and thermal damage,
do not operate the server unless all bays are populated with either a
component or a blank.
NOTE: Depending on model purchased, the server may look slightly
different than shown.
Hot-Plug SCSI Hard Drive
CAUTION: To prevent improper cooling and thermal damage,
do not operate the server unless all bays are populated with either a
component or a blank.
To remove the component:
1. Back up all server data on the hard drive.
2. Open the front bezel ("Removing the Front Bezel (Tower Model)" on page
19
).
To Next Page
Loading...
