Altiris Configuration
NOTE: This feature is neither present nor supported on the HP ThinPro image for the HP t5325 thin
client.
Altiris is disabled by default. It can be activated automatically if the local area network DHCP server
provides Altiris server information through DHCP Tag 190.
To configure or disable Altiris Agent:
1. Click Control Panel > Management > Altiris Configuration.
2. Clear Disable Altiris Agent and specify the Altiris settings in the fields shown.
3. Select Use Multicast: if you want to use the default Altiris server address.
4. The default Multicast Address: is displayed. Type your installation address if necessary.
5. Type or select the Multicast Port: (Altiris server port).
6. If Use Multicast is not selected, type the specific Altiris server address in the TCP Address
field.
7. Type or select the TCP Port: (Altiris server port).
8. Click OK to save your changes and close the dialog box.
ezUpdate
This is a passive management solution based on a specific directory layout on an ftp location. This
directory layout can contain specific instructions for the ThinPro image. If ezUpdate is enabled, when
ThinPro is booted up, it checks this ftp server for new instructions and then carries out those instructions.
112 Chapter 2 Installation ENWW
To Next Page
Loading...
Need help?
General