Deploy HP ThinPro Image from a Remote Site
1. Click Control Panel > Management > Thinstate.
2. Select the HP ThinPro image, and then click Next.
3. Select restore an HP ThinPro image, and then click Next.
4. Select FTP or HTTP protocol. Type the remote server information in the fields.
NOTE: Username and Password are not required if you are using HTTP protocol.
Be sure of the image file you are using: neither content nor size are verified before the image
upgrade begins.
5. Click Finish.
When the image capture begins, all applications stop and a new window appears showing the copy
progress. If a problem occurs, click Details for information. The desktop reappears after restoration
is complete.
A MD5 sum check is done only if the file exists on the FTP server (backup.dd.gz.md5 in the
illustration above).
NOTE: If you abort a restoration, the previous overwritten image will not be restored and the
contents of the flash drive will be corrupted.
Restoration is complete.
120 Chapter 2 Installation ENWW
To Next Page
Loading...
