FUP Commands
File Utility Program (FUP) Reference Manual—523323-014
2-131
LOAD
LOAD
Loads data into a structured disk file without affecting any associated alternate-key
files. Data in the file being loaded is overwritten. This command applies only to
Enscribe files.
To load any alternate-key files, use the command LOADALTFILE on page 2-138 after
you complete a LOAD command.
LOAD in-filename , destination-filename
[ , load-option ] ...
load-option is:
EMPTYOK
FIRST { ordinal-record-num }
{ KEY { record-spec | key-value } }
{ key-specifier ALTKEY key-value }
PAD [ pad-character ]
in-option
key-seq-option
in-option is:
BLOCKIN in-block-length
[ NO ] COMPACT
EBCDICIN
RECIN in-record-length
REELS num-reels
[ NO ] REWINDIN
SHARE
SKIPIN num-eofs
TRIM [trim-character ]
[ NO ] UNLOADIN
VARIN
XLATE [ translation-table-name ]
XLATEIN [ translation-table-name ]
XLATEOUT [ translation-table-name ]
key-seq-option is:
MAX num-records
PARTOF $volume
SCRATCH scratch-filename
SORTED
DSLACK percentage
ISLACK percentage
SLACK percentage
To Next Page
Loading...
