FUP Commands
File Utility Program (FUP) Reference Manual—523323-014
2-26
CONFIG[URE]
CONFIG[URE]
Customizes your FUP configuration information. You can use the CONFIG
abbreviation for this command. The COPY, DUP[LICATE], LOAD, LOADALTFILE, and
RELOAD configuration commands modify the defaults of their corresponding FUP
commands. These modified defaults become applicable when the corresponding
command is executed. The commands apply to other FUP commands as specified.
config-command
specifies FUP configuration information:
COPY copy-option [, copy-option ]...
specifies any of the COPY options (except SOURCE or TARGET file names);
for example, EBCDICIN, BLOCKIN 4096. By default, no COPY options are
configured. For more information, see COPY: Copy Form on page 2-36.
CONFIG[URE] config-command [ config-params ]...
config-command is:
command-option | environment-option
command-option is:
COPY copy-option [, copy-option ]...
DUP[LICATE] dup-option [, dup-option ]...
LOAD load-option [, load-option ]...
LOADALTFILE loadaltfile-option [, loadaltfile-option ]...
RELOAD reload-option [, reload-option ]...
RELOCATE SOURCEDATE
environment-option is:
ALLOW allow-option [, allow-option ]...
DISPLAYBITS bitcount
[ NO ] ECHO [ CONFIG[URE] ] [ OBEY ]
[ NO ] DISPLAYALLNUM
IOTIMEOUT time
NETBLOCKSIZE size
[ NO ] PROMPT [ PURGE ]
REPORTWIDTH width
RESTARTUPDATE time
STATONLY
XLATE xlate-table-name [ TEXT|CHARMAP ]
[ IN filename ]
To Next Page
Loading...
Need help?
General