HP T6553 D45

FUP Commands
File Utility Program (FUP) Reference Manual—523323-014
2-171
SET
SET
Changes one or more file-creation default attributes before you create files. You can
specify parameter values explicitly or set them to match those of an existing file.
To display the current file-creation attributes (the values for create-param), use the
SHOW command. To restore create-param values to the default settings, use the
RESET command.
SET create-param [ , create-param ] ...
create-param for all file types is:
[ NO ] AUDIT
CODE file-code
EXT { extent-size }
{ ( pri-extent-size , sec-extent-size ) }
FORMAT formatcode
LIKE filename
[ NO ] REFRESH
TYPE file-type
create-param for all structured files is:
BLOCK data-block-length
REC record-length
create-param for key-sequenced files is:
[ NO ] AUDITCOMPRESS
[ NO ] BUFFERED
[ NO ] COMPRESS
[ NO ] DCOMPRESS
[ NO ] ICOMPRESS
KEYLEN key-length
KEYOFF key-offset
LOCKLENGTH lock-length
MAXEXTENTS maximum-extents
QUEUEFILE
[ NO ] SERIALWRITES
[ NO ] VERIFIEDWRITES
create-param for partitioned files is:
PART ( sec-partition-num , [\node.]$volume
[ , pri-extent-size [ , [ sec-extent-size ]
[ , partial-key-value ] ] ] )
[ NO ] PARTONLY