HP T6553 D45 User Manual

FUP Commands
File Utility Program (FUP) Reference Manual—523323-014
2-159
RESET Guidelines
RESET Guidelines

Each create-spec keyword in a RESET command resets the corresponding
creation attribute to its default setting. If you do not include create-spec in your
RESET command, FUP resets all creation attributes to their default settings.

If you specify any of the plural keywords (ALTKEYS, ALTFILES, or PARTS), FUP
resets all the corresponding creation values (alternate keys, alternate-key files, or
secondary partitions).
RESET Examples

This example assumes you set the file-creation attributes to create a relative
structured DP2 file $COMPUTR.BOOKS.PASCAL (which is not displayed in this
example) with a record size of 10 bytes and an alternate-key file (named
$COMPUTR.BOOKS.BLAISE). The SHOW command displays:
SET LIKe $COMPUTR.BOOKS.BLAISE
TYPE R
EXT ( 1 PAGES, 1 PAGES )
FORMAT 1
REC 10
BLOCK 1024
ALTKEY ("aa", FILE 0, KEYOFF 0, KEYLEN 5)
ALTFILE (0, $COMPUTR.BOOKS.BLAISE)
config-simple-opts
config-simple-option [ , config-simple-option ]
config-simple-option is:
ALLOW
DISPLAYBITS
DISPLAYALLNUM
ECHO [CONFIG[URE] | OBEY
IOTIMEOUT
NETBLOCKSIZE
PROMPT [ PURGE ]
REPORTWIDTH
RESTARTUPDATE
STATONLY
XLATE [ xlate-table-name ]
XLATEIN [ xlate-table-name ]
XLATEOUT [ xlate-table-name ]
COPY [ copy-option ]
DUP[LICATE] [ dup-option ]
LOAD [ load-option ]
LOADALTFILE [ loadaltfile-option ]
RELOAD [ reload-option ]
Note. For the create-spec parameter default values, see SET on page 2-171. For
config-simple-opts, see CONFIG[URE]
on page 2-26.

HP T6553 D45 Specifications

General

Brand	HP
Model	T6553 D45
Category	Software
Language	English