FUP Commands
File Utility Program (FUP) Reference Manual—523323-014
2-190
Commands Related to SHOW
REC 80
BLOCK 4096
KEYLEN 2
KEYOFF 0
ALTKEY ( "aa", FILE 0, KEYOFF 0, KEYLEN 2, INSERTIONORDER)
ALTFILE ( 0, $DATAA.DCDTEST.ALT0)
ALTCREATE
MAXEXTENTS 16
-EXIT
Suppose these CONFIG[URE] commands are enabled:
CONFIGURE NETBLOCKSIZE 28
CONFIGURE DUP SOURCEDATE
A SHOW CONFIG[URE] command provides this result:
ALLOW ABENDS OFF
NO ECHO CONFIGURE
ECHO OBEY
NO PROMPT PURGE
NETBLOCKSIZE 28
DUP SOURCEDATE
Commands Related to SHOW
STATUS
Reports the status of a reload operation.
OUT listfile
names an existing disk file or a device to receive the listing output from the
STATUS command. You can use either a standard file name or a spool DEFINE
name as the OUT listfile for a STATUS command. If listfile is an existing
file, FUP appends the output to the file.
COMMAND Function Page
CONFIG[URE] Sets some of the attributes displayed by SHOW 2-26
CREATE Creates a file using default file attributes 2-59
RESET Resets default file attributes or CONFIG[URE] options 2-158
SET Sets default file attributes 2-171
STATUS [ / OUT listfile / ] filename [ , DETAIL ]
Note. For more information about listfile, see Specifying Files on page 1-8.
To Next Page
Loading...
