FUP Commands
File Utility Program (FUP) Reference Manual—523323-014
2-27
CONFIG[URE]
DUP[LICATE] dup-option [, dup-option ]...
specifies any of the DUP[LICATE] options (except SOURCE or TARGET file
names); for example, PURGE, SOURCEDATE. By default, no DUP[LICATE]
options are configured. For more information, see DUP[LICATE] on page 2-64.
LOAD load-option [, load-option ]...
specifies any LOAD option (except SOURCE or TARGET file names); for
example, SLACK 20. By default, no LOAD options are configured. For more
information, see LOAD on page 2-131.
LOADALTFILE loadaltfile-option [, loadaltfile-option ]...
specifies any of the LOADALTFILE options (except key-file-number and
primary-filename); for example, MAX 999, SLACK 50. By default, no
LOADALTFILE options are configured. For more information, see
LOADALTFILE on page 2-138.
RELOAD reload-option [, reload-option ]...
specifies any of the RELOAD options (except filename); for example, NEW,
DSLACK 60. By default, no RELOAD options are configured. For more
information, see RELOAD on page 2-148.
RELOCATE SOURCEDATE
By default, no RELOCATE options are configured. For more information, see
RELOCATE on page 2-154.
ALLOW allow-option [, allow-option ]...
specifies the number of errors FUP permits while processing commands. The
default is zero errors. (This option replaces the FUP command ALLOW
on
page 2-9.)
allow-option is:
{ num } [ [SEVERE ] ERRORS ]
{ num } [ WARNINGS ]
[ ABENDS [ ON | OFF ] ]
num
is the maximum number of errors or warnings that can occur before a
FUP command is aborted. The default ALLOW count is 0 for severe
and nonsevere errors; it is unlimited for warnings. The allowable range
for errors is 0 through 32767. FUP keeps an error count internally for
both severe and nonsevere errors.
num ERRORS
sets the nonsevere error count to num.
To Next Page
Loading...
