FUP Messages
File Utility Program (FUP) Reference Manual—523323-014
3-13
Cause. A syntax error occurred in the qualified file-set expression. The additional text
should describe the specific error.
Effect. The command fails.
Recovery. Retry the command after correcting the syntax.
Cause. A syntax error occurred in the attempted command.
Effect. The command fails.
Recovery. Retry the command after correcting the syntax.
Cause. The attempted command specified an illegal value: for example, SET EXT -1.
Effect. The command fails.
Recovery. Retry the command after correcting the value.
Cause. An attempt was made to create a DP2 key-sequenced file with the index block
size and data block size set to different values.
Effect. The CREATE command finishes, but the IBLOCK value for the file is set to its
BLOCK value.
Recovery. If the modified IBLOCK value is not the value required, reset the BLOCK
and IBLOCK values, and retry the command. The index block size must equal the data
block size for DP2 key-sequenced files.
Cause. An attempt was made to execute a command reserved for the super ID
(255,255).
Effect. The command fails.
Recovery. Only the super ID can use the attempted command.
Cause. An internal program error occurred.
Effect. The command fails.
ILLEGAL SYNTAX
ILLEGAL VALUE
INDEX BLOCK SIZE SET EQUAL TO DATA BLOCK SIZE
INSUFFICIENT CAPABILITY
INTERNAL LOAD ERROR: nnn
To Next Page
Loading...
Need help?
General