FUP Messages
File Utility Program (FUP) Reference Manual—523323-014
3-29
Recovery. Change the RECLEN or RECOUT value and retry the command.
Cause. The TAPE DEFINE attribute for TAPEMODE and the FUP parameter for
TAPEMODE were both specified, and they conflict.
Effect. The COPY or BUILDKEYRECORDS command terminates.
Recovery. Modify one of the TAPEMODEs and retry the operation.
Cause. The TAPEMODE and DENSITYOUT parameters were both specified.
Effect. The BUILDKEYRECORDS command fails.
Recovery. Resubmit the command without either the TAPEMODE parameter or the
DENSITYOUT parameter.
Cause. This is not an error. FUP was writing to a tape file and reached the end of the
current reel.
Effect. FUP waits for the next reel to be mounted.
Recovery. Mount the next reel.
Cause. A write request was made, but the write ring was missing.
Effect. The write request to the tape fails.
Recovery. Unmount the tape, insert a write ring, and remount the tape. Press
RETURN to restart the operation.
Cause. An attempt to open a tape file failed with file-system error 194 (device use or
mount request rejected by operator). The operator rejected the request to mount the
specified tape.
Effect. The command fails.
TAPE DEFINE VALUE FOR TAPEMODE CONFLICTS WITH FUP PARAMETER
TAPE DENSITY AND TAPE MODE CANNOT BOTH BE SET
TAPE FULL. MOUNT NEW SCRATCH TAPE
TAPE IS WRITE PROTECTED
TAPE MOUNT REQUEST REJECTED
To Next Page
Loading...
Need help?
General