FUP Command Syntax Summary
File Utility Program (FUP) Reference Manual—523323-014
C-3
BUILDKEYRECORDS primary-filename , out-filename
, key-specifier-list [ , out-option ]
...key-specifier-list is:
{ key-specifier }
{ ( key-specifier [ , key-specifier ] ... ) }
out-option is:
BLOCKOUT out-block-length
DENSITYOUT density
EBCDICOUT
PAD [ pad-character ]
RECOUT out-record-length
[ NO ] REWINDOUT
SKIPOUT num-eofs
TAPEMODE mode
[NO] UNLOADOUT
XLATE translation-table-name
XLATEIN translation-table-name
XLATEOUT translation-table-name
CHECKSUM fileset-list [ , PARTONLY ]
CONFIG[URE] config-command [ config-params ]...
config-command is:
command-option | environment-option
command-option is:
COPY copy-option [, copy-option ]...
DUP[LICATE] dup-option [, dup-option ]...
LOAD load-option [, load-option ]...
LOADALTFILE loadaltfile-option [, loadaltfile-option
]...
RELOAD reload-option [, reload-option ]...
environment-option is:
ALLOW allow-option [, allow-option ]...
DISPLAYBITS bitcount
[ NO ] ECHO [ CONFIG[URE] ] [ OBEY ]
[ NO ] DISPLAYALLNUM
IOTIMEOUT time
NETBLOCKSIZE size
[ NO ] PROMPT [ PURGE ]
REPORTWIDTH width
RESTARTUPDATE time
XLATE xlate-table-name [ TEXT|CHARMAP ]
[ IN filename ]
To Next Page
Loading...
Need help?
General