FUP Overview
File Utility Program (FUP) Reference Manual—523323-014
1-15
Qualified File Sets
ALTKEY
adds, replaces, or alters an alternate-key specification.
AUDITED
specifies files that are audited by the HP NonStop Transaction
Management Facility (TMF).
BROKEN
specifies files that are broken. The file needs media recovery because an
I/O or consistency check failure occurred the last time it was open. A good
example of its use is: WHERE NOT BROKEN.
COLLATION
specifies an SQL collation object.
CORRUPT
specifies any files with questionable contents. The destination file is
marked CORRUPT automatically by FUP during DUP or LOAD operations.
If the DUP or LOAD operation is completed abnormally, the CORRUPT flag
remains set for the file. A good example of its use is: WHERE NOT
CORRUPT.
CRASHOPEN
specifies files not closed normally by the disk process. A good example of
its use is: WHERE NOT CRASHOPEN.
ENSCRIBE
specifies Enscribe files.
ENTRYSEQUENCED
specifies entry-sequenced files.
FORMAT1
describes files that are smaller than 2 GB minus 1 MB size limit. A Format
1 file cannot exceed the 2 GB minus 1 MB size limit.
FORMAT2
describes files that are bigger than 2 GB minus 1 MB size limit. A Format 2
file can exceed the 2 GB minus 1 MB size limit.
Note. The Format 1 files were created on systems running RVUs preceding D46.00
or G06.00. The Format 2 files were created on systems running D46.00, G06.00, or
later RVUs.
To Next Page
Loading...
Need help?
General