Server Storage
3. Follow instructions to Add and Remove Drives from Server Storage
.
Connect an eSATA Disk Drive or SATA Port Multiplier
1. Plug the eSATA cable into the eSATA port on the back of the server, as shown in the following
figure.
2. To plug in and turn on your eSATA disk drive or SATA port multiplier, see the documentation
that came with your device.
3. Follow instructions to Add and Remove Drives from Server Storage
.
Detach and Reattach a USB Drive
In this article...
Detach a USB Drive from the Server
Reattach a USB Drive to the Server
225
To Next Page
Loading...
