HP XP1024 - Mapping Command View CLI Commands to Command View AE CLI Commands; Manual CLI Command Mapping

38 CLI migration
modify HostGroup
create Lun
delete Lun
modify Host Mode
create WWN
delete WWN
create LUSE <data> –lun <data>
Mapping Command View CLI commands to Command View AE CLI commands
NOTE: The command options -csv , -sa, -sd, -cmd,-category,-l,-col,|more and /p for
the Command View CLI are not supported in the Command View AE CLI and cannot be translated.
See Table 14 if you are manually translating Command View CLI command(s) to equivalent Command
View AE CLI command(s) or if you encounter an error for a valid Command View CLI command during
automatic translation.
Table 14 Manual CLI command mapping
Command View CLI
XP512/XP48
Command View CLI
XP128/XP1024/
XP10000/XP12000
Command View AE CLI Automatic translation
support by the CLI
Migration Tool
Commands Command syntax
LUN/LUSE Management commands
list lun list lun [-port
<portname>]
list lun
[-port <port…>
-hostGrp
<grp..>] | [-cu
<cu…> -ldev
<ldev…>]
Hdvmcli
GetStorageArray
subtarget=Path
[serialnum=<array
serial number>
model=<array
type>]
Partially supported.
The CLI Migration Tool
does not support
–hostgrp, -port,
-cu and -ldev
options for translation.
list luse list luse
[-cu <cu>]
list luse [-cu
<cu…> ] [-ldev
<ldev…>]
No equivalent command
exists in the Command
View AE CLI, but you can
get the information you
need by using the list
ldev equivalent
Command View AE CLI
command.
Not applicable.
Migrate to the list
ldev equivalent
Command View AE CLI
command.
list port list port list port
[-hostgrp |
-address
-topology
-security] [
-port
<portname…>]
Hdvmcli
GetStorageArray
subtarget=Port
[serialnum=<array
serial number>
model=<array type>
port=<port id>]
Supported.
NOTE: The output for
the Command View AE
command contains all
port-related data,
although you might only
need specific data, such
as list port
-hostgrp.