84 FAQ
Can the same property file serve as input for multiple command file migrations?
Yes, if all the command files are intended to be executed on the same disk array. Also, since array
configuration is likely to change from time to time, it is suggested that the property file be the latest before
using in migration.
Can the property file that is generated by cmdct be manually repaired/edited?
Yes, but only for certain array types.
For XP128/XP1024/XP12000/XP10000, there are some sections reserved which you may have to edit
depending on specific conditions. The reserved area contains host group details for the create host
group command.
For XP512/XP48, no specific section is reserved for you to edit. Instead, you will need to directly edit the
Command View AE CLI commands in the migration tool’s output file.
The host screen for my host does not show some LUNs assigned for that host
Please ensure that you have added all the arrays attached to your host. After you have added all the
arrays, perform a LUNSCAN for each newly added arrays and refresh the host by clicking the Refresh
button of the host content screen.
Questions about the Device Manager GUI
To Next Page
Loading...
Need help?
General
