8. Connect the data cable to the hard drive and to the system board, as shown in the following figure.
Figure 4-56 Connecting the data cable
9. Connect the power cable (not shown).
10. Reinstall the workstation side access panel.
Processor heatsink
This section describes how to remove and install a processor heatsink.
Not all heatsinks are the same. The heatsink shown in the following figures is an example of what might
be installed in your workstation.
Removing the processor heatsink
To remove a heatsink:
1. Power down the workstation (see
Predisassembly procedures on page 52).
2. Disconnect power from the workstation (see
Predisassembly procedures on page 52).
3. Remove the side access panel (see
Side access panel on page 58).
96 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
