WARNING! This workstation contains a lithium battery. There is a risk of fire and chemical burn if the
battery is handled improperly. Do not disassemble, crush, puncture, short the external contacts, dispose
of in water or fire, or expose the battery to temperatures higher than 60° Centigrade (140° Fahrenheit).
Do not dispose of batteries, battery packs, and accumulators with general household waste.
Customer Self-Repair
Customer Self-Repair enables you to obtain replacement parts and install them on the workstation. For
more information, see
http://www.hp.com/go/selfrepair/.
Predisassembly procedures
Perform the following steps before servicing a workstation:
1. Close all open software applications.
2. Remove all diskettes, CDs, and DVDs from the workstation.
3. Disable the optional solenoid lock (if installed) so side access panel can be removed.
4. Shut down the operating system.
5. Power off the workstation and all peripheral devices connected to it.
6. Remove or disengage security devices that prevent you from opening the workstation.
7. Disconnect the power cord from the electrical outlet and then from the workstation.
8. Disconnect peripheral device cables from the workstation.
52 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
