Item Component Item Component Item Component Item Component
6 Processor 1 fan
connector
16 Clear CMOS button 26 PCI 32 slot 36 Three USB receptacles
7 Second processor
(XU2)
17 Front USB connector 27 PCI 32 slot 37 Two USB and one RJ45
LAN receptacle
8 Memory fan power
connector
18 Internal USB connector 28 PCIe x16 (75W) slot 38 PS/2 mouse and
keyboard jacks
9 Processor 2 fan
connector
19 IDE (PATA) connector 29 PCIe x8 (4) slot * (open-
ended slot that also
allows installation of
x16 card )
10 Diskette drive
connector
20 battery 30 PCIe x16 (75W +) slot
* Electrically x4 bandwidth
Removing and replacing components
This section provides procedures to remove and install hardware components on your workstation.
1. Read all safety information and precautions.
Before servicing your workstation, review the safety information and precautions in
Service
considerations on page 48, and the Safety and Regulatory Information for your workstation.
2. Locate and clear a suitable work area.
3. Power down the workstation and disconnect power from the workstation.
4. Gather your tools.
5. Service the workstation.
6. Restore power to the workstation.
Table 4-3 System board components (continued)
54 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
