Disassembly order
Use the following table to determine the sequence in which to remove major workstation components.
Table 4-4 Workstation component disassembly order
Predisassembly (Predisassembly procedures
on page 52)
Security lock (Security lock padlock loop
(optional) on page 56
Cable lock (Cable lock (optional)
on page 56)
Universal chassis clamp lock (Universal
chassis clamp lock (optional)
on page 57)
Side access panel (Side access panel
on page 58)
Smart Cover Lock solenoid (Smart Cover Lock solenoid
(optional) on page 59)
Hood Sensor (Hood sensor (Smart cover sensor)
on page 61)
Front bezel (Front bezel
on page 61)
Bezel blanks (Bezel blanks on page 62)
Front panel I/O device assembly (Front panel I/O device
assembly on page 63)
Power button assembly (Power button
assembly on page 65)
Optical drives (Optical drive on page 67
Diskette drive (Diskette drive (optional)
on page 69)
System speaker (System speaker
on page 71)
Power supply (Power supply on page 72)
System fan (System fan assembly
on page 73)
Memory fan (Memory fan
on page 74)
Memory (Memory on page 75)
PCI card support (PCI card
support bracket
on page 80)
PCI Express card (PCI Express cards
on page 82)
PCI card (PCI card
on page 84)
ENWW Removing and replacing components 55
To Next Page
Loading...
