4. As shown below, squeeze and hold the two green mounting rail release tabs toward each other
(1), and then slide the hard drive out of the chassis (2).
Figure 4-42 Removing the SAS hard drive
5. Remove the hard drive body from the mounting rails, as shown in the following figure.
Figure 4-43 Removing the hard drive body from the mounting rails
Installing a SAS hard drive
NOTE: Each workstation hard drive bay can be configured at the factory to hold three small form factor
hard drives instead of two standard size drives. To obtain the option kit documentation for removal and
replacement of small form factor hard drives, refer to the HP xw Workstation series - Small form factor
bay converter and hard drive installation user guide at:
http://www.hp.com/support/xw6600 manuals.
88 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
