To remove a SAS hard drive:
1. Disconnect power from the system (see
Predisassembly procedures on page 52).
2. Remove the side access panel (see
Side access panel on page 58).
CAUTION: To prevent damage to the workstation, observe the following Electrostatic Discharge
(ESD) precautions while performing the system parts removal and replacement procedures:
— Work on a static-free mat.
— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your
body to the ground.
— Create a common ground for the equipment you are working on by connecting the static-free
mat, static strap, and peripheral units to that piece of equipment.
3. Disconnect the power (1) and data (2) cables from the hard drive, as shown:
Figure 4-41 Disconnecting the SAS hard drive cables
ENWW Removing and replacing components 87
To Next Page
Loading...
