4. Lift the green drive-lock release tab (1) and slide the hard drive out of the chassis (2), as shown:
Figure 4-49 Removing the SATA hard drive
5. As shown in the following figure, remove the hard drive body from the drive mounting rails and
retain the rails for later use.
Figure 4-50 Removing the hard drive body from the hard drive mounting rails
Installing a SATA hard drive
NOTE: Each workstation hard drive bay can be configured at the factory to hold three small form factor
hard drives instead of two standard size drives. To obtain the option kit documentation for removal and
replacement of small form factor hard drives, refer to the HP xw Workstation series - Small form factor
bay converter and hard drive installation user guide at:
http://www.hp.com/support/xw6600 manuals
92 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
