1. Power on or restart the workstation.
2. As soon as your display is active and F10=Setup appears in the lower right corner of the screen,
press F10 .
If you do not press F10 at the appropriate time, try again. Turn the workstation off, then on, and
press F10 again to access the utility. You can also press the Ctrl + Alt + Delete keys before boot
if you miss the opportunity to press F10.
3. Select your language from the list and press the Enter key.
In the Computer Setup (F10) Utility menu, five headings are displayed: File, Storage, Security,
Power, and Advanced.
4. Use the left and right arrow keys to select the appropriate heading, use the up and down arrow
keys to select an option, and then press Enter.
5. Choose from the following:
●
To apply and save changes, select File>Save Changes, and then select F10=YES.
●
To ignore changes you have made, select Ignore Changes and then select F10=YES.
●
To reset to factory settings, select File>Default setup>Restore Factory Settings as
Default, press F10 to accept the changes and then select Apply Defaults and Exit.
This option restores the original factory system defaults.
CAUTION: Do not power off the workstation while the ROM is saving your Computer Setup
(F10) Utility changes because the Complementary Metal-Oxide Semiconductor (CMOS) could
become corrupted. After you exit the F10 Setup screen, you can disconnect power from the
workstation.
The Computer Setup (F10) Utility menu
NOTE: With new BIOS releases, the following content is subject to change, so your menu might be
different than shown.
Table 3-1 Computer Setup (F10) Utility menu descriptions
Heading Option Description
File System
Information
Displays the following system characteristics:
●
Product Name
●
SKU Number
●
Processor Type/Speed/Stepping
●
Cache Size (L1/L2)
●
Installed Memory Size
●
Integrated MAC 1
●
System BIOS
●
Boot block date
●
Chassis Serial Number
●
Asset Tracking Number
About Displays copyright information.
ENWW The Computer Setup (F10) Utility 25
To Next Page
Loading...
