Heading Option Description
NOTE: This slot receptacle is physically open-ended, which mechanically allows the installation
of a x16 card. However, the slot remains an x4 slot electrically.
Slot 2 — PC
Express x16
Slot 2 option ROM* download (Enable or Disable).
Slot 3 — PCI
Express x8 (4)
Slot 3 option ROM* download (Enable or Disable).
NOTE: This slot receptacle is physically open-ended, which mechanically allows the installation
of a x16 card. However, the slot remains an x4 slot electrically.
Slot 4 — PCI
Express x16
Slot 4 option ROM* download (Enable or Disable).
Slot 5 — PCI Slot 5 option ROM* download (Enable or Disable) plus latency timer.
Slot 6 — PCI Slot 6 option ROM* download (Enable or Disable) plus latency timer.
* Available on selected models.
**These options should be used by advanced users only.
Workstation management
The HP Client Management Solutions (CMS) available for download from http://www.hp.com/go/
easydeploy, are standards-based solutions for managing and controlling workstations in a networked
environment. This section summarizes capabilities, features, and key components of workstation
management, including:
●
Initial workstation configuration and deployment on page 31
●
Installing a remote system on page 32
●
Replicating the setup on page 32
●
Updating and managing software on page 33
●
ROM Flash on page 35
●
Recovering from a ROM flash failure: the FailSafe Boot Block ROM and SoftPaq-created BIOS
image CD on page 36
●
Asset tracking and security on page 36
●
Fault notification and recovery on page 45
●
Dual-state power button on page 45
Support for specific features described in this guide can vary by model and software version.
Initial workstation configuration and deployment
Your workstation includes a preinstalled system software image. After a brief software unbundling
process, the workstation is ready to use.
If you prefer to replace the preinstalled software image with a customized set of system and application
software, several methods are available for deploying a customized software image, including:
●
Installing additional software applications after unbundling the preinstalled software image
●
Using a disk cloning process to copy the contents from one hard drive to another
Table 3-1 Computer Setup (F10) Utility menu descriptions (continued)
ENWW Workstation management 31
To Next Page
Loading...
