3. Remove the bezel blanks by squeezing in on the tabs (1) and simultaneously pushing the bezel
blanks out (2), as shown:
Figure 4-11 Removing the bezel blanks
4. Remove the bezel blank by applying outward pressure on the subpanel (1) and pulling the blank
away (2).
A bezel blank has a hook on both sides. It is symmetric and can be installed upside down without
issue. To replace a blank, align its hook on one side with the slot in the bezel, then rotate it until it
snaps into place.
Front panel I/O device assembly
This section describes how to remove and install a front panel I/O device assembly.
Removing the front panel I/O device assembly
To remove the front panel I/O device assembly:
1. Disconnect power from the system (see
Predisassembly procedures on page 52).
2. Remove the side access panel (see
Side access panel on page 58).
3. Remove the front bezel (see
Removing the front bezel on page 61).
ENWW Removing and replacing components 63
To Next Page
Loading...
