Hood sensor (Smart cover sensor)
To remove the hood sensor:
1. Disconnect power from the system (see
Predisassembly procedures on page 52).
2. Remove the side access panel (see
Side access panel on page 58).
3. Disconnect the white 1x3 hood sensor connector from the in-line connector attached to the front
panel harness.
4. Slide the hood sensor forward, push it down, and remove it from the chassis, as shown:
Figure 4-9 Removing the hood sensor
5. To replace the hood sensor, reverse the previous steps.
Front bezel
This section describes how to remove and replace the front bezel.
Removing the front bezel
To remove the front bezel:
1. Remove the side access panel.
ENWW Removing and replacing components 61
To Next Page
Loading...
