Screen message Probable cause Recommended action
923—Non fatal uncorrectable
PCI error in slot #
A PCI or PCIe non-fatal error condition
occurred for the card in the designated
slot
Move the card to a different slot. If the problem persists,
replace the card.
924—Non fatal correctable
PCI error
Contact HP support.
925—Non fatal uncorrectable
ESI error
Non-fatal, uncorrectable ESI error on
slot # occured.
Contact HP support.
926—Non fatal correctable
ESI error
Non-fatal, correctable ESI error on slot
# occured.
Contact HP support.
927—Non fatal FSB error Non-fatal FSB error on FSB # occured. Contact HP support.
928—Non fatal uncorrectable
FBD error
Non-fatal, uncorrectable FBD error on
DIMM # occurred.
Contact HP support.
929–Non fatal correctable
FBD error
Non-fatal, correctable FBD error on
(DIMM is identified)
Contact HP support.
930–Non fatal internal
Northbridge error
Non-fatal, Internal Northbridge error Contact HP support.
1720—SMART Hard Drive
Detect Imminent Failure
Hard drive is about to fail. (Some hard
drives have a firmware patch that fixes
erroneous error messages.)
1. Determine if hard drive is giving correct error
message.
2. Run the Drive Protection System test (if
applicable).
3. Apply firmware patch (if applicable).
See
http://www.hp.com/support.
4. Back up contents and replace the hard drive.
1783—Fixed Disk 0/1 locked Hard disk drive failure Diagnose the hard drive, and replace it if necessary.
1794—Inaccessible devices
attached to SATA 1 and/or
SATA 3
Missing or improperly attached cable Ensure that a cable is attached. Reattach the cable.
1796—SATA Cabling Error Missing or improperly attached cable Ensure that a cable is attached. Reattach the cable.
1800—Temperature Alert Insufficient coolling Ensure proper fan operation, and increase fan speed.
1801—Microcode Patch Error Processor not supported by ROM
BIOS
Ensure that the installed processor is supported by the
workstation. Upgrade BIOS to proper version for this
workstation and processor.
1802—Processor Not
Supported
The system board does not support the
processor
Replace the processor with a compatible one.
ERROR: An unsupported
processor is installed. System
halted
Unsupported processor detected Replace the processor.
ERROR: A processor requiring
too much power is installed.
System halted
Unsupported processor detected Replace the processor.
ERROR: Mixing processors
with different power
requirements. This is not
supported. System halted.
Mixed type processors detected Replace the processors with matched processors.
Table 5-18 POST error messages (continued)
ENWW POST error messages 133
To Next Page
Loading...
