EasyManuals Logo

HP Z1 G2 Maintenance And Service Guide

HP Z1 G2
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Hide or show the integrated I/O functionality, including serial, USB, or parallel ports, audio, or embedded
NIC. Hidden devices are inaccessible, which increases system security.
Enable or disable removable media boot ability.
Enable or disable removable media write ability (if supported by hardware).
Replicate the workstation setup by saving system conguration information to removable storage or
restoring it.
Accessing Computer Setup (F10) Utility
Accessing Computer Setup (F10) Utility requires a keyboard. To access Computer Setup (F10) Utility:
1. Turn on or restart the workstation.
2. When the display is active and Press the Esc key for Startup Menu appears at the bottom of the screen,
press F10 or Esc.
If you do not press F10 or Esc at the appropriate time, try again. Turn the workstation o, then on, and
press F10 again to access the utility. You can also press Ctrl + Alt + Delete before starting if you do not
press F10 before the message disappears.
3. Select a language from the list, and press the Enter key.
In the Computer Setup (F10) Utility menu, ve headings are displayed: File, Storage, Security, Power,
and Advanced.
NOTE: The option for selecting the language is available on rst boot only. To reset the selection, press
Esc during POST and from the Startup menu, select Change Language to switch between languages.
4. Use the left and right arrow keys to select the appropriate heading, use the up and down arrow keys to
select an option, and then press Enter.
5. Choose from the following:
To apply and save changes, select File and then select Save Changes and Exit. Press Enter to
accept the changes.
To remove changes you have made, select Ignore Changes and Exit, and then press Enter to
acknowledge the cancellation.
To restore factory settings, select File, select Default Setup, and then select Restore Factory
Settings as Default. Press Enter to accept the changes, and then select Apply Defaults and Exit.
CAUTION: Do not turn o the workstation while saving Computer Setup (F10) Utility changes, because the
Complementary Metal-Oxide Semiconductor (CMOS) nonvolatile storage could become corrupted. Turn o
after you exit the F10 Setup screen.
14 Chapter 2 System management

Table of Contents

Other manuals for HP Z1 G2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Z1 G2 and is the answer not in the manual?

HP Z1 G2 Specifications

General IconGeneral
BrandHP
ModelZ1 G2
CategoryDesktop
LanguageEnglish

Related product manuals