HP Z1 G2 - Initial Computer Configuration and Deployment; Installing a Remote System; Copying a Setup Configuration to Another Computer

Initial computer conguration and deployment
The computer includes a preinstalled system software image. After a brief software unbundling process, the
computer is ready to use.
If you prefer to replace the preinstalled software image with a customized set of system and application
software, you can deploy a customized software image using either of the following methods:
●
Installing additional software applications after unbundling the preinstalled software image
●
Using a disk-cloning process to copy the contents from one hard drive to another
The HP Recovery Manager DVDs, ROM-based setup, and Advanced Conguration and Power Interface (ACPI)
hardware provide further assistance with recovery of system software, conguration management and
troubleshooting, and power management.
Support for specic features described in this guide can vary by model and software version.
The best deployment method depends on the information technology environment and processes.
Installing a remote system
When the computer has been congured as a remote system, you can start it and set it up by using software
and conguration information on a network server. This feature is usually used for system setup and
conguration and can be used to perform the following functions:
●
Deploy a software image on new PCs
●
Format a hard drive
●
Install application software or drivers
●
Update the operating system, application software, or drivers
To initiate a remote system installation, press F12 when F12=Network Service Boot appears in the lower
right corner of the HP logo screen. Follow the onscreen instructions to continue the installation process. The
default boot order can be changed in the BIOS so that the system always attempts to boot from the network.
Copying a setup conguration to another computer
This section provides information about replicating the computer setup.
CAUTION: Setup conguration is model specic. File system corruption can result if source and target
computers are not the same model.
To copy a setup conguration:
1. Select a computer to use as the source of the setup conguration.
2. Connect a removable storage device to the computer, and then restart the computer.
3. As soon as the computer turns on, press and hold F10 until you enter Computer Setup (F10) Utility. If
necessary, press Enter to bypass the title screen.
NOTE: If you do not press F10 at the appropriate time, you must restart the computer, and then press
and hold F10 to access the utility.
4. Select File, select Replicated Setup, and then select Save to Removable Storage Device. Follow the
instructions on the screen to create the conguration le cpqsetup.txt and write it to a USB storage
device.
24 Chapter 2 System management