HP Z1 G2 - Hard Drives; Handling Hard Drives; Memory; Supported DIMM Configurations

Hard drives
●
To verify the type, size, and capacity of the storage devices installed in the computer, run Computer
Setup (F10) Utility.
●
The workstation supports SATA hard drives or mSATA devices.
●
The workstation requires one of the following supported carriers:
◦
671193-001 supports one 3.5-in hard drive
◦
671192-001 supports one or two 2.5-in hard drives or solid-state drives
●
Combining a 2.5-in hard drive and 3.5-in hard drive is not possible.
●
No cable adapters are required for any hard drives. The cables necessary for all hard drive congurations
are included in the base system and automatically “blind mate” or “direct connect” to the drive(s) when
installed.
●
The workstation supports mSATA devices in the Mini PCIe/mSATA slots.
Handling hard drives
CAUTION: Take proper precautions when handling hard drives to prevent loss of work and damage to the
computer or drive.
●
Do not remove hard drives from the shipping package for storage. Keep hard drives in their protective
packaging until they are mounted in the computer.
●
Always shut down the operating system, turn o the power, and unplug the power cord. Never remove a
drive while the computer is on or in standby mode.
●
Before handling a drive, be sure that you discharge static electricity. While handling a drive, avoid
touching the connector.
●
Handle a drive carefully. Do not drop it from any height.
●
Do not use excessive force when inserting a drive.
●
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic elds
such as monitors or speakers.
●
If you must mail a drive, use a bubble-pack mailer or other protective packaging and label the package
“Fragile: Handle With Care.”
Memory
Supported DIMM congurations
The HP Z1 G2 Workstation has 4 DIMM slots and supports up to 32 GB ECC or 16 GB non-ECC unbuered DDR3
1866 MHz memory.
NOTE: Mirroring and DIMM sparing are not supported.
●
Four DIMM slots
●
Maximum capacity: 32 GB
●
Error checking and correcting (ECC) and non-ECC DIMMs only.
42 Chapter 3 Component replacement information and guidelines