HP Z1 G2 - Using Computer Setup (F10) Utility to Reset CMOS

Using Computer Setup (F10) Utility to reset CMOS
1. Access Computer Setup (F10) Utility menu.
2. When the computer setup message appears in the lower-right corner of the screen, press F10, and then
press Enter to bypass the title screen, if necessary.
If you do not press F10 while the message is displayed, the computer must be rebooted to access this
utility.
3. From Computer Setup (F10) Utility menu, select File, and then select Default Setup.
This restores the settings that include boot sequence order and other factory settings. However, it does
not force hardware rediscovery.
4. Choose Restore Factory Settings as Default, and then press Enter to accept.
5. Select File > Apply Defaults and Exit, and then press Enter to accept.
6. Reset the computer passwords and conguration information, such as the system date and time.
NOTE: This step does not clear the passwords.
74 Chapter 5 Conguring password security and resetting CMOS