To Next Page

To Previous Page

4 Removal and replacement procedures

Adherence to these procedures and precautions is essential for proper service.

Preparation for disassembly

Use this information to properly prepare to disassemble and reassemble the monitor.

1) Read the “Important safety information” and “Important service information and precautions” sections in

the “Getting started” chapter of this guide.

2) Clean the room for disassembly.

3) Identify the disassembly area.

4) Check the position that the monitors are to be placed along with the number of monitors. Prepare the area

for material flow according to the disassembly layout.

5) Be sure to have the following equipment and materials:

 Press fixture

 Working table

 Screwdriver

 Knife

 Gloves

 Cleaning cloth

 ESD protection

 Scraper bar in the following dimensions:

Rear Cover

Before removing the Rear Cover, follow these steps:

▲ Prepare the monitor for disassembly. See Preparation for disassembly on page 13.

1) Pull the release button to remove Stand Base From Display Head

Other manuals for HP Z24U G3

Questions and Answers:

Need help?

Do you have a question about the HP Z24U G3 and is the answer not in the manual?

General