HPE 5920 series

The HPE 5900AF-48XG-4QSFP+, 5900AF-48XG-4QSFP+ TAA, 5900CP-48XG-4QSFP+, 5900CP-48XG-4QSFP+ TAA, and
5900CP-48XG-4QSFP+8Gb FC B-F switches come with the power supply slots empty and the filler modules for the slots as
accessories. You can install one or two power supplies for the switch as needed. In this figure, two 650W AC power supplies are
installed. For more information about installing and removing the power supply, see Installing/removing a power supply on
page 27.
The HPE 5900AF-48XG-4QSFP+, 5900AF-48XG-4QSFP+ TAA, FlexFabric 5900CP 48XG 4QSFP+, 5900CP-48XG-4QSFP+
TAA, and 5900CP-48XG-4QSFP+8Gb FC B-F switches also come with the fan tray slots empty. You must install two fan trays
for the HPE 5900AF-48XG-4QSFP+, 5900AF-48XG-4QSFP+ TAA, 5900CP-48XG-4QSFP+, 5900CP-48XG-4QSFP+ TAA, and
5900CP-48XG-4QSFP+8Gb FC B-F for adequate heat dissipation, and their models must be the same. In this figure, two
LSWM1FANSC fan trays are installed. For more information about installing and removing the fan tray, see Installing/
removing a fan tray on page 25.
Figure 39: Left side panel
(1) Primary grounding point
(2) Auxiliary grounding point 1
HPE 5900AF-48XGT-4QSFP+/HPE 5900AF-48XGT-4QSFP+ TAA
Figure 40: Front panel
(1) 1/10GBase-T autosensing Ethernet port
(2) 1/10GBase-T autosensing Ethernet port LED
(3) QSFP+ port (4) QSFP+ port LED
(5) System status LED (SYS)
52 Chassis views and technical specifications