HPE 5920 series

Connecting the power cord
CAUTION:
• Provide a circuit breaker for each power supply.
• Before you connect the power cord for a power supply, make sure that the circuit breaker for the power supply is
turned o.
Procedure
•
Connecting the 650W AC power supply on page 31
• Connecting the 650W DC power supply on page 32
Connecting the 650W AC power supply
Procedure
1. Insert the female connector of the AC power cord supplied with the power supply into the power receptacle on the power
supply.
2.
Use a cable tie to secure the power cord to the handle of the power supply, as shown in Figure 24: Connecting the 650W
AC power supply on page 31.
3.
Connect the other end of the power cord to an AC power outlet.
Figure 24: Connecting the 650W AC power supply
(1) Cable tie
(2) Fasten the cable tie to secure the power cord to the handle of the power supply
Installing the switch 31