HPE 5920 series

Item Specification
Transmission medium and max transmission
distance
100 m (32808 ft) over category-5 twisted pair cable
Compatible standards
• IEEE 8023i
• IEEE 8023u
• IEEE 8023ab
1/10GBase-T autosensing Ethernet port
The HPE 5900AF-48XGT-4QSFP+ and HPE 5900AF-48XGT-4QSFP+ TAA switches have 1/10GBase-T autosensing Ethernet
ports.
Table 14: 1/10GBase-T autosensing Ethernet port specifications
Item Specification
Connector type RJ-45
Port transmission rate 1/10 Gbps, full duplex, MDI/MDI-X autosensing
Transmission medium and max transmission
distance
• 55 m (18045 ft) over category-6 unshielded twisted pair cable
• 100 m (32808 ft) over category-6 shielded twisted pair cable
• 100 m (32808 ft) over category-6A or above twisted pair cable
Compatible standards
• IEEE 8023ab
• IEEE 8023an
To avoid interference between cables, layer cables as follows:
• Use category-6A or above twisted pair cables and connectors.
• Do not bundle cables in their first 20 m (6562 ft).
• Separate power cables and twisted pair cables at and around the distribution frame.
• For ports adjacent to one another on the device, the peer ports on the distribution frame is preferably not adjacent, for
example:
◦ If the device connects to one distribution frame, connect port 1 on the device to port 1 on the distribution frame, port 2
on the device to port 3 on the distribution frame, and port 3 on the device to port 5 on the distribution frame.
◦ If the device connects to two distribution frames, connect port 1 on the device to port 1 on distribution frame 1, port 2
on the device to port 1 on distribution frame 2, and port 3 on the device to port 2 on distribution frame 1.
LEDs
System status LED
The system status LED shows the operating status of the switch.
Ports and LEDs 67